Think of ways to higher a BC1's RPM or BC2 (Bearing Core 1 and Bearing Core 2)
Although it is useless to some people, because this might create a wild Wobbler, others enjoy wobblers, and would like to make them.
Also share your opinion about Wobblers. And why or why not you should make BC1-2 combos' spin rate higher..
Increase spin rate? Fix the shaft, use mint condition tip. You can try magnetising the shaft, using error packs, etc.
Note that the smoother the bearings, the easier it is to wobble and the lower the spin rate. Crazy wobblers... are not neccassarily the ones with good spin rate.
Use Metal Ape and C.Heavy with anyone of them... And giving Bearing Core 2 more spin rate is not good...
One thing I noticed about Bearing core2 is that the rubber tends to grind with the plastic... And the whole RC is hollow and the top metal part supportive the nail like shaft... If Takara did'nt make the RC hollow, then maybe there would be less wobbling... Personally I hate the wobbling...
| QUOTE (Time @ Mar 28 2005, 07:23 AM) |
Use Metal Ape and C.Heavy with anyone of them... And giving Bearing Core 2 more spin rate is not good...
One thing I noticed about Bearing core2 is that the rubber tends to grind with the plastic... And the whole RC is hollow and the top metal part supportive the nail like shaft... If Takara did'nt make the RC hollow, then maybe there would be less wobbling... Personally I hate the wobbling... |
You can wear down the rubber, I think... and also, polish? Grease?
